Dusk To Dawn Light Socket Photocell, White
from Carlon Home Products
- "LAMSON" DUSK TO DAWN LIGHT SOCKET
- Lamp socket adapter.
- Turns light on at dusk and off at dawn.
- 1. 2 amp, 150 watts, 120 v. a. c. , 60 Hz. U. L. listed
Light control screws into the fixture, bulb screws into control. Aim light sensor at strongest source of natural light and it will automatically turn on at dust and will turn off at dawn. Saves energy, provides all night security. Use with 120 volt AC, 150 watt incandescent bulb.
Intermatic HB61RC Digital Outdoor Timer Photo Control
from Intermatic
- Highly versatile control with choices of operation modes
- Photo on/Photo off mode offers automatic on at dusk, off at dawn
- Photo on/Timer off mode provides automatic on at dusk, off at owner's selection in 1 hour increments form 1 to 9 hours
- Immediate on/Timer off mode provides immediate on, off at owner's selection in 1 hour increments from 1 to 9 hours
* Highly versatile control with choices of operation modes * Photo On/Photo Off mode offers automatic On at dusk, Off at dawn * Photo On/Timer Off mode provides automatic On at dusk, Off at owner's selection in 1 hour increments from 1 to 9 hours * Immediate On/Timer Off mode provides immediate On, Off at owner's selection in 1 hour increments from 1 to 9 hours * 10 amp lighting capacity * Manual override * Grounded, compact 6 inch cord
Intermatic NE2C Night Eye Dual Photo Cell
from Intermatic
- Ideal security light system to automatically turn lights on at dusk
- Provides safety, security, and convenience
- 120-volt
- 150-watt incandescent
- UL listed
Designed to provide safety, security, and convenience, the Intermatic night eye dual photocell automatically turns electrical loads on at dusk, and off at dawn. An advanced technology circuit saves 25-percent of conventionally used energy, and reduces output light levels when on. The photocell screws into any standard incandescent light socket for added versatility, and will control both interior and exterior lights.
Dusk to Dawn Photo Control with Emergency Flasher. Turns lights ON at dusk, OFF at dawn. Emergency flasher is activated when power is turned OFF and ON again twice in a 10 second period. Lights will flash for 60 minutes and reset automatically. Turning power OFF and back ON again can also stop flashing.
Intermatic NE200C Par Lamp Photo Control.
from Intermatic
- 28 Watts Compact Fluorescent
- 120 VAC, 60 Hz
- 150 Watts Incandescent
- Provides Safety, Security and Convenience
Automatically turns floodlights, spot lights, PAR lamps, halogen lamps and PL lamps (screw-in fluorescents) On at dusk and Off at dawn. For adding after-dark security to residential and commercial driveways, entrances, and patios. For indoor or outdoor use. No seasonal adjustments necessary. Includes sensor window shade to reduce lamp flickering. UL, CSA and NOM listed. 150 watts, 120 Volts AC, 60 Hz.
Designers Edge L-1795-BR 150 Watt Equivalent Wattage Flourscent Dusk To Dawn Wall Light
from Designers Edge
- 2-light downward fluorescent wall sconce designed for style and functionality
- UL and CL listed for safety
- Die-cast metal housing; bronze finish; acrylic prismatic globe
- Features dusk-to-dawn photocell
- Includes two 13-watt fluorescent bulb; limited 2-year warranty
EMX IRB-4X Infrared Photoeye Safety Sensors
from EMX Industries, Inc.
- The IRB-4X works without lenses so it is easy to align.
- LED alignment indicator on the receiver simplifies installation.
- Contains an electronic sunlight filter. Features automatic compensation for temperature changes.
- 24 degrees of alignment freedom. Capable of penetrating 70% obstruction due to fog, steam and spray
- Immune to vibration. Does not require additional signal amplifiers or relay boxes.
IRB-4X transmitter and receiver are mounted in line of sight at a distance of up to 75 feet. When the infrared beam is broken the internal relay is de-energized and detection signal is produced on the relay contacts. The red LED indicator on the receiver is lit when the IRB-4X receiver is not aligned or when the beam is interrupted. Features: Infrared transmitter in a weather-proof NEMA 4X enclosure, Infrared receiver in a water-proof NEMA 4X enclosure including 5A120V AC relay output. Supervised relay output provides a "detect" signal in case of power failure. Non-reflective through-beam system is not affected by shiny surfaces. Modulated infrared beam is not affected by sunlight, rain, dust or dirt. Wide transmission angle of 24-degrees simplifies installation and increase the reliability of operation. Wide temperature operating range for applications from cold storage to steamy food prep areas.
Security Photo Light Control, 300 Watt
from Tyco Electronics
Electrical components ultraviolet stabilized polycarbonate. For control of porch lights or outdoor floodlights. 300 watts, direct-wire.
Precision Products Plus 79583-PPP Black Pagoda (Wall Mount) with Photo Cell and One 18-Watt Compact Fluorescent Light Lamp, Energy Star Rated
from Precision Products Plus
- Energy Star
- Electronic ballast
- Includes one 18 watt lamp
- Photo cell turns on/ off at dawn and dusk
- Wall mount fixture
EMX MVP D-TEK Loop Detector for Gate and Traffic Control
from EMX Industries, Inc.
- First automatic Multi Voltage Power detector to operate in both fail safe and fail secure modes
- One detector covers all the voltages
- Enhanced Lightning/Surge immunity
- Aluminum RF shield housing
- Loop isolation transformer. Gold plated control contacts .
EMX Industries Inc. has designed the MVP D-TEKTM for applications where vehicle detection is needed. MVP D-TEKTM makes it simple to manage your stock. All you need is one detector in your stock room and on your truck. The MVP D-TEKTM solves the problem of not knowing which voltage to take for service call or an installation. Reduce the costs of inventory by stocking only one universal voltage loop detector. Features: First automatic Multi Voltage Power detector to operate in both fail safe and fail secure modes. One detector covers all the voltages. Enhanced Lightning/Surge immunity. Aluminum RF shield housing. Loop isolation transformer. Loop diagnostics. Frequency counter. Gold plated control contacts. 2 relays (presence & pulse or presence).
EMX NIR Retro-Reflective Photoeye Safety Sensors
from EMX
- Can be used as a reversing sensor for commercial overhead doors, gates and parking barriers
- Flexible Voltage 12V AC/DC to 240V AC. Watertight Package, 30 feet range, 6 foot cord.
- Bracket and Mounting hardware included. Two LED Indicators, Sensitivity adjustment.
- Compact water-tight design allows for outdoor installation
- Mounting hardware and indicators make it easy to install.
The NIR Retro-Reflective Photoeye can be used as a reversing sensor for commercial overhead doors, gates and parking barriers.
+++
